- MicroCurrent - LED - Other Tools
- LED Light
- ZAQ Noor 2.0 LED Light Therapy Neck Mask
ZAQ Noor 2.0 LED Light Therapy Neck Mask
ZAQ Noor neck mask is made of flexible silicone for safe and comfortable use.
The ZAQ Noor neck mask emits a selection of four therapeutic light colors from 57 LED bulbs. Exposing even the most sensitive facial skin to various wavelengths of light, helps improve many common skin concerns.
Not suitable if pregnant, thyroid conditions, or ulcerated skin. Please consult with your doctor if unsure of usage.
Red is effective at treating conditions on the top layers of the skin, including:
- Reducing acne inflammation and breakouts.
- Reduction of fine lines, sagging skin, sun damage, and wrinkles.
- It has been used to accelerate skin wound healing.
- Some doctors use it to reduce skin swelling and inflammation.
Yellow is commonly used to help promote healing of eczema, sunburn, psoriasis, rosacea, and to reduce overall redness.
Blue light has many physical and mental health benefits. It is proven to have antibacterial properties, and overall cleanses the skin. On an emotional level, blue light has been used to treat addiction and depression.
It alleviates inflammation, increases cell regeneration, and has a balancing and calming effect on the skin.
Users find improvements in the following areas:
- Blood circulation
- Slowed skin aging, wrinkle and fine line formation
- Natural oil production that may lead to acne
- Noticeable collagen growth
- Tightening the skin.
- Improved appearance of skin imperfections
LED light can also help promote:
- lymphatic drainage
- skin elasticity
LED light targets specific cells to help to improve many common skin concerns.
TO GET STARTED
To charge the control panel, attach the charging cable to the controller at the bottom where the circle is – this is the charging point. This will start to charge the control unit.
White LED Lights will start to appear as the unit charges – M1 will appear first – all the way to M4. Once all four white LED lights on the controller are lit, your control panel is fully charged. Remove the charging cable. (All 4 LED lights will then go off which is normal)
Connect the control panel to the cable attached to the mask and you are ready to commence treatment.
HOW-TO USE GUIDE
Attach the straps to the mask at either side. Adjust so that the mask is sitting on the skin but is not uncomfortable tight to wear.
Hold the top on/off button down for 2 seconds and the M1 light will appear as well as the M (Manual) light. The initial LEDs that light up are the RED. By pressing the top button again the selection moves to BLUE, press again and then it moves to YELLOW and then finally PURPLE.
Once you select your desired program you can stop pressing the power selection button and the treatment time will start after 5 seconds for a treatment time of 10 minutes. Simply relax.
You can press and hold the power/selection button for up to 3 seconds to turn the LED neck mask off at any stage. For the first four weeks, as we recommend you use for less than the fixed 10-minute program, we would suggest you time your treatments to enable you to manually switch off
Once you have completed treatment remove the neck mask and wipe it with a warm damp cloth too clean. Store safely.
Limit use to no more than 5 minutes at a time every 3 days.
Increase use to once every 2 days, no more than 5 minutes at a time.
Increase time to 10 minutes at a time. Limit use to every 2 days.
You can use it once every day (if needed), no more than 10 minutes at a time.
Use as per instructions to see visible results after 4-6 weeks.
After consistent use:
skin will look noticeably brighter and smoother;
fine lines and wrinkles are less visible